It is a powerful program complex intended to record and analyze signals of different dynamic processes. The sources of signals can be different: the data can come from DAQ devices in real-time or from a recorded file. It is possible to analyze the data acquired with RULA devices or imported from other acquisition systems.

Possible applications:

  • Viewing the waveform of the recorded signal;

  • Spectrum graphs: calculation of spectrum density, RMS or amplitude spectrum;

  • Statistical analysis: calculating RMS, median, minimum and maximum values in the preset fragment of time; calculating the absolute acceleration value on 3 axes; calculating standard deviation;

  • Signal integration and double-integration, calculating the absolute value and sigma-clipping;

  • Arithmetic operations: adding, dividing or multiplying a signal by a signal or a constant, subtracting a signal from a signal or a constant;

  • Filtration with FIR or IIR filters. You can specify the filter type: high-pass, low-pass, band-pass, band-stop, and the frequency parameters (cut-off frequencies and attenuation ratio);

  • Shock response spectrum;

  • Waterfall analysis;

  • Data recording;

  • Modal analysis.

Windows integration

VisAnalyser software integrates into any Windows system, starting from Windows 7 and later. To start work, you are to install the program using the installation wizard and run the software.

Data export

If you want to use an analysis function, which is not implemented in VisAnalyser software, there are two possible solutions:

  • export the data into CSV or binary format to view it in Matlab, LabVIEW, etc.;
  • implement your own reading program according to open specifications.

  • Title 1
    Tab content 1